Monitoring
NRPE
It is possible to monitor Baruwa Enterprise Edition systems using the NRPE protocol
from Nagios. To enable monitoring check the Enable Monitoring
checkbox on the
System Settings
screen of the baruwa-setup
utility.
Monitoring points
Depending on the system profile, the following points are available via NRPE.
- Disk space
- Uwsgi process
- Database process
- Database proxy process
- Indexer process
- Cache process
- Message Queue process
- Baruwa celery process
- Baruwa Logging process
- Mail Scanning process
- Anti Virus Engine process
- Message queue status
- System Load
- Security Updates
Adding your own monitoring points
You can add your own NRPE monitoring points by placing a .cfg
file in /etc/nrpe.d
then reload the nrpe
service to activate the monitoring points.
Monitoring services
You can monitor the services by connecting to the actual port, most monitoring systems are able to do this.
Firewall
The firewall port 5666 inbound is open to all, you need to restrict this by allowing access only from your monitoring IP addresses.